Open 24/7 · Kyle, TX

Faucet Repair in Kyle, TX

A dripping faucet wastes water all day and often points to a small worn part. Faucet repair in Kyle, TX covers kitchen, bathroom, laundry and outdoor taps, from a single phone call.

Emergency? Call now, 24/7(737) 717-0737
Cutaway of a home showing the plumbing systemWater main and sewer main under the street, a water heater in the garage, a toilet, a kitchen sink, drain lines and the sewer line. Numbered hotspots link to services.Water mainSewer mainWater heater1Drains2Leaks and pipes3Sewer line4Toilets and fixtures5
  1. Say what the faucet doesDrips from the spout, leaks at the base, weak flow, or a stiff handle.
  2. The cause is foundWater is shut off at the stop valve and the faucet is opened up.
  3. The worn part is replacedA cartridge, seat, washer or O-ring goes in, then the faucet is tested.
Why call us

Why call for a faucet

Small leaks add up, and a faucet is a short job when handled right.

  • Open all hoursA faucet that will not shut off at night can be reported then.
  • Same-day service is availableExplain the drip or leak and a visit can be set for today.
  • Every fixture on one numberKitchen faucet, bathroom vanity, tub spout or hose bib all go through the same call.
  • A person answersYou can describe the faucet in your own words.
  • No formsNo online booking page to wrestle with while the cabinet fills.
We vs others

Faucet trouble: this number versus the usual route

Six differences, from the first ring to the final drip test.

UsOnion Creek PlumbingvsMany other plumbing companies
HoursOpen 24/7A burst supply line under a sink does not wait for morning.Weekday office hours
Reaching someoneA person answersDescribe the brand or the symptom.A web form
How soonSame-day service is availableSmall jobs are not pushed to the back of the line.A date next week
What jobs they handleRepair and replacement of any faucetPlus supply lines and shutoff valves.Only new installs
Local knowledgeCovers Kyle and 18 nearby townsHard-water scale on aerators is a regular sight.Generic advice
Price clarityThis page explains what moves the price. Ask about pricing when you call.Parts and fixture age lead.A price after the faucet is apart

Based on what is typical. Individual companies vary.

How it works

How faucet repair in Kyle, TX works

Four steps. The first one saves you from a mess.

  1. Close the stop valve

    The small valve under the sink or at the wall shuts off water to the faucet only.

  2. Take it apart

    The handle, cap and cartridge or washers come out in order.

  3. Replace the worn part

    A new cartridge, seat, O-ring or washer goes in. Mineral deposits are cleaned off.

  4. Reassemble and test

    Water is turned on slowly. The faucet runs hot and cold with no drips.

Pricing

What moves the price of faucet repair in Kyle, TX

Some faucets repair in minutes. Others cost more to fix than to replace. Here is why.

Faucet type

Cartridge and ceramic-disc faucets use different parts than older compression taps.

Parts availability

A common brand has parts on the shelf. A discontinued or imported model may not.

Condition of the fixture

Pitted or corroded finishes and bodies often cost less to replace than to restore.

Valves and supply lines

A seized stop valve or a cracked supply line is replaced during the job.

Number of fixtures

Several faucets that are worn together can be handled in the same visit.

Have this ready for the call

  • Which faucet leaks and what it does
  • Brand name if visible
  • Whether the stop valve under it turns
  • Any water under the sink or on the floor

Ask about pricing when you call.

Call now, 24/7(737) 717-0737
Why faucets drip

The parts inside a faucet that wear out

A drip almost always comes from one small piece.

From the handle to the spout

A faucet is a valve you operate by hand. Inside, a seal presses against a seat to stop flow. Turn the handle and the seal lifts. Over time, water pushes grit and minerals against the seal and the seat, and the rubber wears. A worn seal lets a thin stream slip by even with the handle closed. That is a drip.

Around the stem and body, rubber O-rings keep water from escaping upward. When those wear or dry out, water seeps around the handle or the base. A cracked or loose spout swivel can leak in the same way. A drip counted at a drop per second adds up to a noticeable amount in a month.

Inside a faucet
  • Washer or sealPresses on the seat to stop flow. Wears from grit.
  • SeatThe metal ring the seal presses on. Can pit or corrode.
  • O-ringsSeal the stem and spout swivel. Dry out with age.
  • CartridgeControls flow and mix. Wears or scales.
  • AeratorScreen at the spout tip. Catches grit and scale.
Parts most often responsible for a drip.
Faucet types and their parts

Four faucet designs and how each one fails

The fix depends on which kind you have.

Look at how the handle works and how many there are. The table covers the four common designs and the usual repair for each.

DesignHow to tellUsual wear pointTypical repair
CompressionTwo handles that you turn several timesRubber washers, worn seatsReplace washers and seats
BallSingle handle on a rounded cap, common on kitchen faucetsSprings, seals, the ball itselfRebuild with a kit
CartridgeOne or two handles; smooth lift and swingO-rings and the cartridgeReplace the cartridge
Ceramic discSingle lever, very smooth motionDisc seals, inlet sealsReplace the cylinder
Touch or sensorTaps on and off by touch or motionBatteries, solenoid, control modulePart or unit replacement
Look at the handle before you look up parts.

If a faucet is old, pitted and out of production, replacement often wins. See plumbing repair for what a plumber looks at before recommending it.

Leaks by location

Where the water shows up tells you the cause

The place a faucet leaks is the best clue to which part failed.

Reading the leak

Water at the spout tip when the handle is off points to the seal, seat or cartridge. Water around the base or under the handle points to O-rings or a loose body. Water that appears only when the faucet is running often comes from a cracked spout or a spout swivel.

Under the sink is a different story. Supply lines can crack or weep at their nuts. Shutoff valves can leak at the stem. A drain connection can drip from a loose slip nut or a worn washer. Those drips can look like faucet trouble, so dry everything with a towel and watch where the first bead of water appears.

Leak location
Where water showsLikely causeUsual fix
Spout tip, handle offWorn seal, seat or cartridgeReplace the inner parts
Around handleStem O-ring or packingReplace O-ring or packing
Base of faucetBody O-ring or loose mountReplace O-ring, tighten mount
Cabinet, at supply lineCracked line or loose nutReplace the supply line
Cabinet, at the stop valvePacking or valve seat wornReplace the stop valve
Cabinet, at the drainSlip nut or washerReseat or replace the drain parts
Dry everything first, then watch for the first drop.

A leak inside the wall or from the supply pipe itself is a pipe repair matter, not a faucet one.

Weak flow and scale

Scale, hard water and faucet repair in Kyle, TX

Weak flow from one faucet is usually mineral buildup, not the house supply.

What hard water does to faucet parts

City of Kyle water tested between 275 and 295 mg/L in 2025, roughly 16 to 17 grains per gallon, and the City’s own report labels anything over 180 mg/L very hard. That figure applies to City customers only. Other utilities serve a few nearby neighborhoods, and the number drifts through the year, so your bill or your water supplier is the place to confirm your own address.

Hardness shows up first at the aerator, the small screen at the spout tip. White, crusty buildup narrows the openings, so the stream sprays sideways or weakens. Deposits can also lock a cartridge or cake the seat so the faucet no longer seals. Unscrew the aerator and soak it in vinegar for a few hours. Often the flow returns. If it does not, the cartridge is next.

For the bigger picture, see water softener installation and the hard water guide.

Cleaning an aerator
  1. Unscrew the aerator

    Turn it counterclockwise by hand or with a cloth and pliers.

  2. Soak in vinegar

    A few hours dissolves most mineral crust.

  3. Rinse and refit

    Rinse, brush off loose bits and thread the aerator back on.

  4. If flow stays weak

    A scaled cartridge or a clogged supply line may be the cause.

A quick check before calling.
Outdoor faucets

Hose bibs and outdoor taps in a Texas climate

Sun, heat and the occasional hard freeze take a toll on outside taps.

What goes wrong outdoors

An outdoor faucet sees weather that indoor fixtures never meet. Summer sun bakes rubber washers and packing. A hose left attached through a freeze traps water in the faucet and can split the body or the pipe just behind the wall. The split may not show until the thaw, when water runs inside the wall.

A hose bib that drips from the handle needs new packing or a repacked stem. One that drips from the spout needs a new washer or seat. One that leaks inside the wall when the hose is on needs a closer look. Many outdoor taps have a vacuum breaker, a small cap on the spout that stops water flowing backward. A leak there means the breaker is worn and should be replaced. Irrigation connections feed from the same supply, so a leak near the valve box is a different job.

Hose bib trouble
  • Drip from the handlePacking nut or stem packing.
  • Drip from the spoutWasher or seat.
  • Spray from the vacuum breakerWorn breaker cap.
  • Water inside the wallSplit pipe behind the faucet.
  • Frozen spigotDo not force it; thaw slowly.
Outdoor faucet symptoms.

Read the burst pipe guide if the pipe behind the faucet has split.

Repair or replace

When to replace a faucet instead of repairing it

A good repair on a good faucet is quick. A bad repair on a bad faucet costs time.

Repair makes sense when the faucet is sound and parts are easy to find. Replacement makes sense when it is damaged, outdated or has failed more than once.

SituationRepairReplace
Single drip, faucet in good shapeSwap the cartridge or sealNot needed
Finish is flaking or pittedRepair will not fix the lookReplace the fixture
Parts are discontinuedHard to sourceReplace with a current model
Body is cracked or corrodedWill not holdReplace
Faucet leaks repeatedly after repairSeat or body is damagedReplace
Remodel or style changeNot applicableReplace and update supply lines
Match the fix to the faucet’s condition.
After the repair

Keeping faucets from dripping again

Small habits reduce wear.

  1. Close handles gently

    Cranking a handle shut grinds the seal against the seat.

  2. Clean the aerator twice a year

    A quick soak keeps scale from building up.

  3. Replace supply lines on a schedule

    Braided lines last years, but they can burst. Replace if they bulge or rust.

  4. Test the stop valves

    Turn them once or twice a year so they do not seize.

  5. Disconnect hoses before a freeze

    Drain and cover outdoor taps in cold snaps.

  6. Fix drips promptly

    A drip you can count wears the seat deeper each day.

Questions

Faucet repair in Kyle, TX: common questions

Why is my faucet dripping?
A seal, washer, O-ring or cartridge has worn and no longer closes tight. Grit and minerals speed that wear. Replacing the worn part usually ends the drip, though a pitted seat may need to be replaced as well.
How much does faucet repair in Kyle, TX cost?
It depends on the faucet type, parts availability, the condition of the fixture and whether valves or supply lines also need replacing. Ask about pricing when you call.
Why do faucet repairs vary so much in price?
A common cartridge faucet may need one part. A discontinued model may need replacing outright, and a seized stop valve adds work. Ask about pricing when you call.
Can a dripping faucet be fixed without replacing it?
Usually yes. A worn cartridge, washer or O-ring costs little and takes little time. The exception is a faucet with a pitted body or discontinued parts, where replacement makes more sense.
How much water does a dripping faucet waste?
More than most people expect. A steady drip can waste many gallons over a month, and the loss shows up on the water bill. Fixing it early is the easy path.
Why is the water flow from my faucet weak?
A scaled aerator or cartridge is the usual cause, especially with hard water. Soak the aerator in vinegar. If flow stays weak, call. If every fixture is weak, read low water pressure.
Can faucet repair be done the same day?
Same-day service is available. Say which faucet is the problem and what it does, and a visit can be set for today.
Is the line open at night?
Yes. The line is open 24/7. Water under a sink at night can be reported then. Close the stop valve under the sink in the meantime.
What should I do if water is leaking under the sink?
Close the stop valves under the sink. If they will not turn, close the main water valve. Dry the area, put a bowl under the leak and call. The main valve guide shows where to look.
Do you repair outdoor hose faucets?
Yes. Dripping handles, worn washers and failed vacuum breakers are all common repairs. A split pipe behind the faucet after a freeze is a different job, but the same call covers it.
Is it better to repair or replace an old faucet?
If it is sound, a repair is fine. If the finish is worn, parts are discontinued or it leaks again after repair, replacement is the better move. See toilet installation for how fixture replacement goes.
Can hard water ruin a faucet?
It shortens the life of cartridges and clogs aerators with scale. City of Kyle water tested 275 to 295 mg/L in 2025, which the City report calls very hard. Cleaning aerators and treating the water both help.

Faucet dripping or leaking? Call now.

Tell us what the tap is doing and faucet repair in Kyle, TX can happen today. Open 24/7.

Call now, 24/7(737) 717-0737