Open 24/7 · Kyle, TX

Sewer Line Replacement in Kyle, TX

Some sewer pipes are past the point where patching helps. If your line is collapsed, sagging or failing along its length, talk to a plumber about sewer line replacement in Kyle, TX. Open 24/7, with same-day service available.

Emergency? Call now, 24/7(737) 717-0737
Cutaway of a home showing the plumbing systemWater main and sewer main under the street, a water heater in the garage, a toilet, a kitchen sink, drain lines and the sewer line. Numbered hotspots link to services.Water mainSewer mainWater heater1Drains2Leaks and pipes3Sewer line4Toilets and fixtures5
  1. Call about the symptomsBackups, smells, wet ground, or a camera result you already have.
  2. The line is mappedIts path, depth and condition are confirmed before work begins.
  3. A new pipe goes inThe old run is replaced or bypassed and the flow is tested.
What we help with

Pages that connect to a new sewer line

Replacement sits at the end of a longer chain of decisions. These pages cover the steps before it.

Sewer camera inspection

The recording that shows if replacement is needed.

Sewer camera inspection details →

Sewer line repair

A smaller fix when only a section has failed.

Sewer line repair details →

Trenchless sewer repair

New pipe with far less digging.

Trenchless sewer repair details →

Hydro jetting

Cleaning that comes before inspection.

Hydro jetting details →
Start here

Signs that a sewer line is beyond patching

One backup does not mean a new line. A pattern does. These are the signs that usually lead to replacement. Red cards need action first.

Backups that return after every cleaningThe line is cleared, relief lasts a short time, and the same drains stall again.When replacement makes senseA camera shows a collapsed or crushed pipePipe that has caved in cannot be cleared. It has to be replaced or relined.When replacement makes sensePipe that sags into a bellyA low section holds waste and water, and solids settle there again and again.Choosing materialsRoots throughout the runRoots at many joints, not one, mean the old pipe has too many weak points to fix one by one.When replacement makes senseSewage coming up in the houseStop using water, keep clear of the spill, then call.What to do right nowA sinking, wet strip across the yardSoil that drops along the line often follows a broken pipe underneath.How a new line goes inOld iron or clay pipePipe that is shedding flakes, scale or fragments is wearing out from the inside.Choosing materialsSewage reaching electrical itemsDo not touch wet outlets or cords. Switch off power only from a dry spot, then call.What to do right now
Why call us

Why call about a replacement project

A new line is a big decision. The first conversation should be easy to start.

  • Answered whenever you callSewer trouble gets worse overnight, so the number works nights and weekends.
  • Same-day service is availableIf the line is failing right now, a visit does not need to wait.
  • Talk to a personExplain the camera result or the symptoms. No forms, no portal.
  • The whole chain on one numberCleaning, camera work, repair and replacement can all be discussed on the same call.
  • Your address matters, and we askWhether you are on a City of Kyle sewer or another provider shapes where the new line connects.
We vs others

Replacement conversations compared

What the first call can look like next to the usual route.

UsOnion Creek PlumbingvsMany other plumbing companies
AvailabilityOpen 24/7You can raise the question the night the drain fails.Business hours only
Reaching someoneA person answers, no formDescribe the line and any camera findings.A contact form and an email thread
How soonSame-day service is availableAn urgent backup is handled first, planning follows.A visit weeks out, even for an active backup
What jobs they handleClearing, camera, repair and replacementYou are not passed between companies.A firm that only digs, or only cleans
Local knowledgeSoil that swells and shrinks, plus the City of Kyle systemBoth affect the design of a new line.A template plan that ignores local ground
Price clarityThe page names the cost driversNumbers come after the line is assessed.A rough guess before anyone has seen the pipe

Based on what is typical. Individual companies vary.

How it works

From first call to a working new line

Four stages. The details depend on the method chosen.

  1. Explain and assess

    You describe the symptoms. The plumber asks about age of the house, trees and past trouble.

  2. Confirm the condition

    A camera run records what is in the pipe, and a locator marks the path and depth.

  3. Choose the method

    Open trench, pipe bursting or lining, depending on the pipe and the surface above it.

  4. Install and test

    The new pipe is laid or pulled in, connected at both ends, and water is run through it.

Pricing

What changes the cost of sewer line replacement

Replacement is the sewer job with the widest spread in cost. These are the reasons.

Length of the line

The longer the run from the house to the connection, the more pipe and labor.

Depth

A deeper line means a deeper trench or pits, and more shoring and spoil to move.

What sits on top

Grass, a driveway, a patio or a slab each need different restoration afterward.

Method chosen

Trench, bursting and lining differ in equipment and in how much surface work is needed.

Obstacles

Trees, fences, other utilities and tight side yards all slow the work.

Have this ready for the call

  • Where the cleanout is
  • What the camera showed, if you have a recording
  • Trees, driveways or structures along the line
  • How long the drains have been giving trouble

Ask about pricing when you call.

Call now, 24/7(737) 717-0737
When replacement makes sense

Sewer line replacement in Kyle, TX versus patching what you have

Repair, reline or replace

A plumber weighs three things: how much of the pipe is bad, what shape the rest is in and how likely the line is to fail again. One broken joint in an otherwise good pipe is a repair. A line with root entry at several joints and a long sag is a candidate for replacement.

The camera picture drives the choice. If the pipe walls are intact, a liner can seal cracks. If the pipe has collapsed or lost its shape, there is nothing for a liner to adhere to and the old pipe needs to be removed or burst apart. A line that has to be reopened every season is costing more in service calls than its cleaning ever saves.

It also helps to look ahead. If the yard is going to be dug for another reason, or a tree is coming down near the line, those are good moments to address the pipe at the same time.

Decision guide
What the camera showsTypical directionWhy
Single cracked jointSpot repairThe rest of the pipe is sound
Cracks along a stretch, shape intactLiningA liner can seal the walls
Collapse or heavy sagReplacementNo sound surface to line
Roots at many jointsReplacement or liningToo many entry points for repeat cleaning
Iron pipe flaking insideReplacementThe pipe is thinning throughout
A guide to the decision. The recording settles it.
How the camera result points the way.
Choosing materials

What a new sewer pipe is made of

PVC, ABS and other options

Most new residential sewer lines in this part of the country are plastic: PVC or ABS in solid-wall form. Both are smooth inside, which helps waste move, and both resist the corrosion that eats iron. Plastic pipe is also light enough to handle in a tight yard and comes in lengths that reduce the number of joints.

The pipe is only part of the system. Bedding is the layer of sand or fine gravel the pipe rests on, and it matters as much as the material. A well-bedded pipe holds slope and resists the push and pull of clay soil. A pipe laid on lumpy backfill can sag and bring back the very problem you are paying to remove.

Some projects use pipe that is fused into one continuous length, such as HDPE, which is pulled through the old route during trenchless sewer repair. The plumber chooses a material to match the method and the conditions on site.

Materials
MaterialStrengthsWatch for
PVCSmooth, rigid, resists corrosionNeeds good bedding to hold slope
ABSTough and used widely for drainsJoints must be cleaned and cemented carefully
HDPEFused into a continuous length for pulling inNeeds special fusing equipment
Cast ironHeavy and long-lived in some usesRusts through from the inside over time
Clay tileCommon in older linesMany joints, easy for roots to enter
General properties. The plumber picks for your situation.
Pipe types compared.
How a new line goes in

What replacing a sewer line looks like on site

  1. Locate and mark

    A locator traces the pipe and marks its path. Other buried services near it are located before anything is opened.

  2. Open or bore

    A trench is dug along the route, or small pits are opened at each end for a trenchless method.

  3. Lay or pull the new pipe

    The pipe goes in at the right slope. In a trench it rests on bedding. In bursting, it follows the old line.

  4. Connect and flow test

    Both ends are tied in and water is run to confirm the line drains freely.

  5. Backfill and restore

    Soil is returned in layers. Lawn, paving or slab work follows as needed.

Not every project uses every step. The guide to trenchless versus traditional sewer repair explains the digging side, and the sewer line replacement guide covers what drives the total.

Local ground and service

Clay ground and the City of Kyle sewer system

What affects a new line here

Soil is the first local factor. Clay-heavy ground, found across much of Central Texas, can swell when wet and shrink in dry spells. A rigid pipe on poor bedding can be stressed by that motion, so the bedding and the pipe’s slope get extra attention. This is general behavior, and the plumber checks your own site.

The second factor is who serves your address. The City of Kyle provides wastewater service inside the area it is authorized to serve, which can differ from the city limits. Its two treatment plants discharge to Plum Creek, and an expansion is underway. Other utilities serve some neighborhoods nearby. Look at your bill or use the City’s address lookup, because the connection point for a new line follows the serving utility’s setup.

Homes on septic do not have a sewer lateral to a city main. Mention that at the start of the call, because the work is a different kind.

Before the work
  • Serving utilityCheck your bill or the City’s address map.
  • Where the lateral endsAsk the utility where the public main begins.
  • Slope and beddingClay can shift a pipe that has no firm base.
  • Trees along the routeRoots will find a new pipe too, if there is a gap.
  • Septic or sewerA septic home needs a different plan.
Local points to settle early.
Right now

What to do if the line fails before replacement is planned

  1. Stop using water

    Each flush or drain adds to a line that cannot take it.

  2. Protect the room

    Lift belongings off the floor. Keep children and pets away from wet areas.

  3. Switch off nearby power

    Only from a dry spot. If the panel is wet, stay out.

  4. Note what you saw

    Which drains, what came up and how long ago. This helps when the line is inspected.

  5. Call any hour

    Same-day service is available.

Wastewater carries germs.

Wear gloves and boots if you have to enter a wet area. Wash hands well afterward. Do not run a household vacuum through standing sewage.

After the new line

Looking after a new sewer line

  1. Keep a recording

    A camera run on the new pipe is a record of how it should look. See sewer camera inspection.

  2. Limit what goes down

    Even a new pipe clogs on grease, wipes and paper towels.

  3. Plan around trees

    A new line is smoother than an old one, but roots still look for a gap.

  4. Know the cleanout

    A tidy, reachable cleanout makes any future work faster.

  5. Read the cost guide

    The article on sewer line replacement cost lists what to ask about.

Service areas

Where we work

Sewer line replacement is handled in Kyle and the towns below. Share your address on the call, because the serving utility affects the plan.

Towns within about 25 milesSchematic map of towns within about 25 miles of Kyle10 mi20 mi25 miBuda, about 7 miles1Maxwell, about 7 miles2Manchaca, about 9 miles3Austin, about 10 miles4San Marcos, about 11 miles5Martindale, about 11 miles6Lockhart, about 12 miles7Dale, about 15 miles8Wimberley, about 17 miles9Bee Cave, about 18 miles10West Lake Hills, about 21 miles11Cedar Creek, about 21 miles12Kingsbury, about 22 miles13Dripping Springs, about 23 miles14New Braunfels, about 24 miles15Lakeway, about 25 miles16Canyon Lake, about 25 miles17The Hills, about 25 miles18Kyle
Schematic map. Rings show distance from Kyle; positions are approximate.
Questions

Sewer line replacement in Kyle, TX: common questions

When do I actually need to replace my sewer line?
When the pipe has collapsed, sagged badly, shows damage along most of its length, or keeps failing after repairs. A camera recording is the best evidence. One crack is usually a repair.
How much does sewer line replacement cost?
It depends on the length, depth, method, what sits above the pipe and obstacles on the route. Ask about pricing when you call, and have your camera findings handy if you have them.
Can I get sewer line replacement in Kyle, TX at night?
Yes. The line is open 24/7 and same-day service is available. If sewage is backing into the house, stop using water and call right away.
How long does a sewer line replacement take?
That varies with the length, depth, method and surface. A short trenchless job can be quicker than a long open trench. The plumber can give a better picture once the line has been inspected.
Will you tear up my whole yard?
Not necessarily. Trenchless methods use small pits at each end. A trench is still the right answer in some cases. See trenchless sewer repair to compare.
Is a liner as good as a new pipe?
A liner works well when the old pipe is still round and structurally intact. It does not rescue a collapsed pipe. The camera result decides.
What happens to the old pipe?
In a trench job it is removed. In pipe bursting it is broken up and left in the ground as the new pipe is pulled through. Lining leaves it in place.
Do tree roots grow into a new sewer line?
They can if there is a loose joint or a gap. Modern solid-wall pipe with tight joints resists them far better than old clay tile, but trees near the route are still worth discussing.
Does the City of Kyle replace my sewer line?
The utility looks after the public main. The lateral from your house is generally your side. Boundaries vary, so check your bill or ask the utility which provider serves your address.
Can I use my plumbing while the work is going on?
Usually not while the line is open. The plumber will say when water use can resume and how long to avoid it.
What if I only have a slow drain?
A slow drain alone points to a local clog. Try drain cleaning first. Replacement is for lines with a confirmed structural fault.
Should I get a camera inspection first?
Yes. It confirms the diagnosis and rules out cheaper options. See sewer camera inspection.
Guides

Read more on sewer replacement

Is the sewer line failing?

Call any hour to talk through sewer line replacement in Kyle, TX. Same-day service is available.

Call now, 24/7(737) 717-0737